Brugger Feinmechanik GmbH
Erzgießereistraße 30
D-80335 Munich
+49 89 525507
+49 89 5233436
HSG-C - Heat-Sealing Mashine
The HSG-C is designed for testing the heat sealability of varnished or coated films. The HSG-C has a removable pair of sealing jaws which temperature may be individually set between ambient temperature and 300°C. In addition, you may control the dwell time and the sealing force. The actual and set temperatures as well as the dwell time and sealing force are shown in the display.
If your lab is not equipped with a compressed-air supply, use our special HSG-C Compressor Version. You may wish to obtain our special software to evaluate the results for documentation purposes. For sealing jaws with a smooth surface the sealing pressure will be automatically calculated and displayed from the set sealing force.
If your lab is not equipped with a compressed-air supply, use our special HSG-C Compressor Version. You may wish to obtain our special software to evaluate the results for documentation purposes. For sealing jaws with a smooth surface the sealing pressure will be automatically calculated and displayed from the set sealing force.
Test the seam strength of the sealed samples with our Universal Tensile Tester VNG-E.
An optional Hot Tack Device can be obtained as an accessory.
Also, an optional load cell enables you to adjust the force display any time. You may adjust the Temperature, Force and Time parameters with our newly developed HSG-P testing device.
Download Datasheet
An optional Hot Tack Device can be obtained as an accessory.
Also, an optional load cell enables you to adjust the force display any time. You may adjust the Temperature, Force and Time parameters with our newly developed HSG-P testing device.
Download Datasheet
| Specifications | |
| Test method |
Simulation of a head sealing equipment to determine the best sealing parameters |
| Compressed-air supply |
max. 10 bar |
| Seal jaws |
150 x 100 mm² smooth(standard). Other specifications upon request |
| Seal temperature |
From ambient temperature up to 300°C max. (top and bottom sealing jaws can be separately adjusted) |
| Tolerance |
< 1.5% FS |
| Sealing force |
40N up to 990N for the entire sealing area |
| Tolerance | < 1.5% FS |
| Dwell time | 0.1 - 50.0 s |
| Tolerance | 0.3% FS |
| PC interface |
serial standard interface RS232, 9.600 Baud |
| Interface for force adjustment |
Internal protocol |
| Dimensions |
68 x 35 x 44 cm |
| Weight |
24kg |
| Storage temperature |
0°C - 50°C |
| Working temperature |
15°C - 35°C |
| Relative humidity |
max. 80%, non-condensing |
| Electrical connection HSG-C |
230 V / 50 - 60Hz, power consumption ca. 500W, approx. |
| Standard |
Following ASTM F 2029 - 00 |
Accessories
Required Accessories
Optional Accessories
Optional Accessories
- Other sealing jaws
- Hot Tack
- Strip Cutter
- HSG-P
- Load Cell
- Software
- PC Equipment
- Printer
- Mains Connection
- Compressed-Air connector ( 6 - 10 bar )
- PT 100
- Sealing jaws
- Fixing Springs for the sealing unit
- Heating cartridge
- fuses