Brugger Feinmechanik GmbH
Erzgießereistraße 30
D-80335 Munich
+49 89 525507
+49 89 5233436
HSG-C - Heat-Sealing Machine with Compressor
The HSG-C is designed for testing the heat sealability of varnished or coated films. The HSG-C has a removable pair of sealing jaws which temperature may be individually set between ambient temperature and 300°C.
In addition, you may control the dwell time and the sealing force. The actual and set temperatures as well as the dwell time and sealing force are shown in the display. If your lab is equipped with a compressed-air supply, we recommend our standard HSG-C without compressor.
You may wish to obtain our special software to evaluate the results for documentation purposes. For sealing jaws with a smooth surface the sealing pressure will be automatically calculated and displayed from the set sealing force.
An optional Hot Tack Device can be obtained as an accessory. Test the seam strength of the sealed samples with our Universal Tensile Tester VNG-E.
Also, an optional load cell enables you to adjust the force display any time. You may adjust the Temperature, Force and Time parameters with our newly developed HSG-P testing device.
In addition, you may control the dwell time and the sealing force. The actual and set temperatures as well as the dwell time and sealing force are shown in the display. If your lab is equipped with a compressed-air supply, we recommend our standard HSG-C without compressor.
You may wish to obtain our special software to evaluate the results for documentation purposes. For sealing jaws with a smooth surface the sealing pressure will be automatically calculated and displayed from the set sealing force.
An optional Hot Tack Device can be obtained as an accessory. Test the seam strength of the sealed samples with our Universal Tensile Tester VNG-E.
Also, an optional load cell enables you to adjust the force display any time. You may adjust the Temperature, Force and Time parameters with our newly developed HSG-P testing device.
| Specifications | |
| Test method |
Simulation of a head sealing equipment to determine the best sealing parameters |
| Compressed-air |
max. 10 bar with built-in compressor |
| Sealing jaws |
150 x 10 mm² smooth (standard). Other specifications upon request |
| Sealing temperature |
From ambient temperature up to 300°C max. (top and bottom sealing jaws can be separately adjusted) |
| Tolerance |
< 1.5% FS |
| Sealing force |
40 N up to 990 N for the entire sealing area |
| Tolerance | < 1.5% FS |
| Dwell time | 0.1 - 50.0 s |
| Tolerance | 0.3% FS |
| PC interface |
serial standard interface RS232, 9.600 Baud |
| Interface for force adjustment |
Internal protocol |
| Dimensions |
64 x 44 x 122 cm |
| Weight |
76 kg |
| Storage temperature |
0°C - 50°C |
| Working temperature |
15°C - 35°C |
| Relative humidity |
max. 80%, non-condensing |
| Electrical connection HSG-C |
230 V / 50 - 60Hz, power consumption ca. 500W, approx. |
| Standard |
Following ASTM F 2029 - 00 |
Accessories
Required Accessories
Optional Accessories
Optional Accessories
- Strip Cutter
- Hot Tack
- Strip Cutter
- HSG-P
- Load Cell
- Software
- PC Equiment
- Printer
- Mains Connection
- Compressed-Air Connector (6 to 10 bar)
- PT 100
- Sealing jaws
- Fixing Springs for the Sealing Unit
- Fuses